The effect of etching time duration on the push out strength of self adhesive cement to root dentin

https://doi.org/10.53730/ijhs.v6nS10.13703

Authors

  • Mohsin Yarmohammadi DDs, Dentistry Student, Aja university of Medical Sciences, Dentistry School, Tehran, Iran
  • Elnaz Shafigh MSC, Assistant professor of operative department, dentistry faculty, Aja university, Tehran, Iran
  • Mahdie Jamshidian MSC, Assistant Professor of Operative Department, Dentistry Faculty, Aja university, Tehran, Iran

Keywords:

self adhesive resin, fiber post, pre-etching

Abstract

Introduction: Post debonding is one of the most important causes of restoration failure in endodontically treated teeth restored with fiber-post. The weakest connection in post-cement-dentin complex is cement-dentin bonding surface. In this study we evaluated the effect of etching with phosphoric-acid and its duration on push-out strength of self-adhesive resin cement to dentin. Materials and Method: Root canal therapy was done for fifty intact one-canal premolars then the crown was cut from CEJ. Fiber-post space was prepared in the root canal by FGM special drill. The teeth were randomly divided into five groups of ten teeth. Group without any intervention was considered as control-1 and the other groups were prepared for etching. Three groups were etched with 37%phosphoric-acid for 15seconds, 60seconds and 90seconds. In the last group, after preparation, etching protocol wasn't performed which was considered as control-2. In all samples, White post fiber-ost(FGM) size2 was cemented with self-adhesive cement TheraCem (Bisco) and divided into two 4mm pieces and then mounted in acryl. Push-out test was performed by Instron machine for each sample and the shear bond strength was obtained in MPa. 

Downloads

Download data is not yet available.

References

Cormier, C. J., et al. (2001). In vitro comparison of the fracture resistance and failure mode of fiber, ceramic, and conventional post systems at various stages of restoration. Journal of Prosthodontics,10(1),26-36.

DEVARASA, G. M., et al. Self-etching adhesive on intact enamel, with and without pre-etching. Microscopy research and technique 2012, 75.5: 650-654.

Fokkinga, W. A., et al. (2004). A structured analysis of in vitro failure loads and failure modes of fiber, metal, and ceramic post-and-core systems. International Journal of Prosthodontics,17(4),

Goodacre, C. J., et al. (1994). The prosthodontic management of endodontically treated teeth: a literature review. Part I. Success and failure data, treatment concepts. Journal of Prosthodontics,3(4),243-250.

HILTON, Thomas J., et al. Summitt's fundamentals of operative dentistry: a contemporary approach/edited by Thomas J. Hilton, Jack L. Ferracane, James C. Broome; Illustrations by Jose dos Santos Jr. Fourth Edition, 2013.

Holderegger, C., et al. (2008). Shear bond strength of resin cements to human dentin. Dental Materials,24(7),944-950.

Monticelli, F., et al. (2008). Limited decalcification/diffusion of self-adhesive cements into dentin. Journal of dental research,87(10),974-979.

Nemati Anaraki S., et al. (2014) Comparison of the effect of self-adhesive and self-etch cement on the retention of DT Light fiber post. Journal of research in dental sciences 142(3)-151

PARČINA, Ivana; AMIŽIĆ, Anja Baraba. Esthetic intracanal posts. Acta Stomatologica Croatica, 2016, 50.2: 143.

Rahshenas N., et al. (2013) Self-etch versus self-adhesive resin cements: effect on shear bond strength of fiber posts to dentin. Journal of research in dental sciences 111(2)-151

RITTER, Andre V., et al. Sturdevant's art and science of operative dentistry/edited by Andre V. Ritter, Lee W. Boushell, Ricardo Walter. Seventh Edition, 2019.

ROSENSTIEL, Stephen F.; LAND, Martin F. (ed.). Contemporary Fixed Prosthodontics,2015.

SAKER, Samah; ÖZCAN, Mutlu; AL-ZORDK, Walid. Theimpact of etching time and material on bond strength of self-adhesive resin cement to eroded enamel. Dental Materials Journal, 2019, 2018-126.

Sidle DM, et al. (2008). Determination of shear srength of periosteum attached to bone with BioGlue surgical adhesive. Arch Facial Plast Surg 10(5):316-20

Soares, C. J., et al. (2012). Influence of resin cement and post configuration on bond strength to root dentine. International endodontic journal,45(2),136-145.

Swift, J. E. J. (2012). Self‐Adhesive Resin Cements—Part II. Journal of Esthetic and Restorative Dentistry,24(4),287-291.

Vaz, R. R., et al. (2012). Bond strength and interfacial micromorphology of etch‐and‐rinse and self‐adhesive resin cements to dentin. Journal of Prosthodontics: Implant, Esthetic and Reconstructive Dentistry,21(2),101-111.

‏WANG, Xiaodong, et al. Evaluation of fiber posts vs metal posts for restoring severely damaged endodontically treated teeth: a systematic review and meta-analysis. Quintessence International, 2019, 50.1.

Published

30-11-2022

How to Cite

Yarmohammadi, M., Shafigh, E., & Jamshidian, M. (2022). The effect of etching time duration on the push out strength of self adhesive cement to root dentin. International Journal of Health Sciences, 6(S10), 856–862. https://doi.org/10.53730/ijhs.v6nS10.13703

Issue

Section

Peer Review Articles